cloverleaf-heater

CloverLeaf Heaters

'Cloverleaf' Electric Heaters:
 
From Cloverleaf: The Pond Heater with Intelligent Digital Control!

This particular Pond Heater is manufactured using the finest materials available. Its body is 316L stainless steel; the highest grade produced. The Titanium heating element is the most efficient of its type in the world. The unique state of the art intelligent digital thermostat can sense water flow reduction and prevent dry burn out.

Please Note:
If you are a fish keeper that likes to run salt in your system then refer to the Pure Titanium range of heaters below..

Easy to plumb in to your existing pipework ..
A complete installation kit is supplied including mounting brackets, easy release couplings, universal hose tails for flexible pipe when solvent connection is not required........
the heater inlet and outlets are made to take  1.5" clear hose tails (supplied) .....
Or unions to connect directly into your 1.5" solvent weld  black pipework (also supplied)
 so it is a very simple job to fit these 'Cloverleaf' heaters into your system, and have it running, within a matter of a couple of hours.
A complete kit is supplied including mounting brackets, easy release couplings, universal hose tails for flexible pipe to make instillation very simple for this Cloverleaf Heater.......


These Cloverleaf heaters are IP55 rated. EU, TUV & UL approved. C
Models Available: 1kw, 2kw & 4kw
As a handy guide for you to make an informed choice about what size of heater you will require to heat your pond we suggest that on average 1kw of power is suitable per 1000 gals (4450ltrs) of pond water.
Which equates to:
1KW (up to 1000 gals)
2KW (up to 2000 gals)
4KW (up to 4000 gals)
The Cloverleaf Heater with the Titanium flow tube and also Titanium body is suitable for all salt water applications. Fish Ponds, Lobster Vats, Marine and all water where there is salt present in any ppm.
Even if you only run salt in your system once in a 'blue moon' over a period of time Stainless Steel will degenerate and leach into your water, although a little more expensive be safe and choose Titanium.

CloverLeaf Heater - S/S Body & Titanium Element

CloverLeaf Heater
Stainless Steel Flow Tube Body & Titanium Element
complete with DigiStat

CloverLeaf Heater - Titanium Body & Titanium Element

CloverLeaf Heater
Titanium Body & Titanium Element
complete with DigiStat
WARNING: If your system is a PUMP FED system - then you MUST make provisions to be able to REMOVE THE HOSETAILS once per month to enable you to 'FLUSH' out the body of the Heater using the normal hose pipe .. Failure to do this simple task will cause debris and waste matter to collect on the element which (if not removed) in time may cause the element to burn out.
FAILURE TO OBSERVE THIS ADVICE -  WILL INVALIDATE THE GUARANTEE ....